CUSTOM TRUCK LOAD KING 25-92, Руководство по установке

Страница: 16 / 171

INSTALLATION REQUIREMENTS
PTO SELECTION
PTO ROTATION:
The rotation direction of a PTO is defined
while looking at the output shaft of the
PTO.
PUMP ROTATION:
The rotation direction of a pump is
defined while looking at the input shaft of the
pump.
EXAMPLE:
A PTO with an output shaft that rotates
CW (clockwise) requires a CCW (counter­
clock wise) pump.
When ordering your PTO, be sure to
know the rotation direction of your pump, this
will aid your PTO selection.
It is imperative that the rotation direction of
the Load King supplied pump match the PTO
out­put shaft rotation direction. Either CW or
CCW rotation pumps are available form Load
King .If the pump supplied with your crane is
the wrong rotation direction, contact Load
King customer ser­vice.
Do not attempt to rotate the pump in the
wrong direction. Pump failure will result.
The Load King supplied pump has an SAE - B
2-Bolt mounting flange and a 7/8"
(22.225mm) x 13 spline x 1.62in (41 mm) long
splined input shaft. Specify the PTO with this
output mounting provision.
Before installing the PTO, test fit the pump
into the PTO output mounting flange to verify
that the pump housing seats on the PTO
mount housing before the pump shaft bottoms
in the PTO output shaft. Failure to check for
adequate pump shaft end clearance may
damage both pump and PTO.
The PTO manufacturer will supply installa­
tion instruction specific to the PTO model
being installed. Follow these instructions and
direct any installation questions to the PTO
manufacturer's customer service department.
Page 2 -
6
CONTACT WITH A ROTATING
DRIVELINE COMPONENT WILL CAUSE
SERIOUS INJURY OR DEATH
KEEP CLEAR OF ROTATING DRIVE
SHAFT
NEVER WORK ON AN INSTALLED
POWER TAKE-OFF WITH THE
ENGINE RUNNING
Note: Keep the protective covers
on the
pump inlet and outlets until
the hoses are ready to be installed to
keep dirt out!