Custom Equipment HY-BRID LIFTS HB-1030, Инструкция по эксплуатации и безопасности

Страница: 22 / 28

OPERATIONS & SAFETY
HB-1030/HB-1430 SUPO 610
REV M
22
5.2 | STARTUP/SHUT DOWN
DANGER
THE OPERATOR MUST BE AWARE OF THE ENVIRONMENT.
DO NOT RAISE THE PLATFORM IF THE MACHINE IS NOT
ON A FIRM, LEVEL SURFACE.
Operation Startup & Shutdown Practices
• Check that the work area is safe.
• Ensure that the key in the lower control panel is in the “ON” position.
• Machine must be on a hard, level, surface before operation.
• Enter the work platform in the stowed position using the constant three point contact method.
• Follow all general rules and precautions stated in this manual
• When finished with the machine, place the platform in the stowed position.
• Park the machine on a level surface.
• Carefully exit the platform using the constant three point contact method.
NEVER JUMP OFF PLATFORM.
• Remove key from lower control panel to prevent unauthorized use.
5.3 | DRIVING AND STEERING
WARNING
CHECK THAT THE ROUTE OF TRAVEL TO BE TAKEN IS CLEAR OF
PEOPLE, OBSTRUCTIONS, DEBRIS, HOLES, AND DROP-OFFS; AND
IS CAPABLE OF SUPPORTING THE MACHINE.
Always check front steer wheel direction before driving. If there is resistance in turning the casters while pivoting the
machine, steer forward to allow the casters to straighten out before turning.
For best control, distribute the load on the work platform toward the rear of the machine if possible.
To activate drive function, select drive mode using the switch on the platform control box.
To drive, hold the joystick trigger while moving the joystick. Moving the joystick will cause the machine to drive in
that direction. Moving the joystick handle away from the operator will cause FORWARD travel, and pulling the joystick
toward the operator will cause REVERSE travel. Moving the joystick directly to one side or the other will cause the
machine to pivot. Travel speed is proportional and is controlled by the joystick. The farther it is moved, the faster the
speed will be. The joystick returns to the neutral position when released.
Braking: For parking, the brake is automatically applied when the joystick is positioned in the center (neutral) position.
In the event of a machine failure, the machine can be pushed by releasing the parking brake at the rear of the ma-
chine. See Section 4.3 on page 19 for brake release information.
SECTION 5 | OPERATION