CC200 / CC400
General Production Hose Crimper
6
DIE SET UP AND INSTALLATION
• Dies are available for the CC200 crimper in 84S, 99S and 130S Series
• Dies are available for the CC400 crimper in 84S, 99S and 145S Series
• A set of 130mm O.D - 99mm I.D. Intermediate Dies is furnished with the
CC200 crimper.
• A set of 145mm O.D - 99mm I.D. Intermediate Dies is furnished with the
CC400 crimper.
The I.D. of the intermediate die must match the O.D. of the hydraulic die or
accurate crimps are not possible.
INDUSTRIAL DIE INSTALLATION
INTERMEDIATE ADAPTER DIE INSTALLATION
Turn on the crimper at the master power switch.
Bring the master dies to the full open position as shown in photo A, or to the
position where the die removal tool can be inserted to release the retaining
spring.
Insert the die removal tool in the release hole to release the retaining spring
as shown in photo B.
Attach either an Intermediate Adapter Die or an Industrial Die to the Master
Die as shown in photo C.
Note: The numbers stamped on the face of the die should face the operator.
Note that on some crimpers the master dies must be slightly closed in order
to completely insert the die removal tool.
Mount all 8 dies in a similar manner as shown in photo D.
If 130mm O.D. Dies are being used, proceed to crimping
Operating instructions and set up the crimper for the correct
crimp diameter.
If Hydraulic Dies are being used, see Hydraulic Die Installation
instructions.
A
B
C
D
