Custom Audio Electronics VKP80II-EE, Руководство пользователя

Страница: 34 / 84

BUSY CONDITION
Activation mode for Busy signal:
RXFull D = Busy signal is activated when the buffer is full
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status
and the buffer is full
NOTE: Parameter valid only with serial interface; using this parameter, it is possible to select whether
the Busy signal is activated when the printer is both in Off Line status and the buffer is full or only if the
reception buffer is full.
USB ADDRESS NUMBER
Numerical address code for the univocal identifi cation of the USB device (in case of
more than a USB device connected with the same PC):
0
D
3 6 9
1 4 7
2 5 8
NOTE: This parameter is used to identify univocally the USB printer by a numerical address code, if on
the PC are connected two printers that are the same models.
AUTOFEED
Setting of the Carriage Return character:
CR disabled
D
= Carriage Return disabled
CR enabled = Carriage Return enabled
PRINT MODE
Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
CHARS / INCH
Font selection:
A = 11 cpi, B = 15 cpi
A = 15 cpi, B = 20 cpi
D
NOTA: CPI = Characters Per Inch
SPEED / QUALITY
Setting of printing speed and printing quality:
High Quality
Normal
D
High Speed
PAPER RETRACTING
Setting of the “retract” function of the paper, with paper presence on ejector during
power-up:
Disabled D = “retract” function disabled
Enabled = “retract” function enabled
NOTE: During power-up, if paper is present on the ejector and if this parameter is set to “Enabled”, the
printer will retract the paper. Otherwise, if the parameter is set to “Disabled”, the printer will eject the paper.
NOTCH ALIGNMENT
Alignment management:
Disabled D = the notch alignment is not performed
Enabled = the notch alignment is performed
NOTCH THRESHOLD
Threshold value (in percent) for the recognition of the presence of notch by the notch
sensor:
0,5 1,5 2,5 3,5 4,5
1,0 2,0
D 3,0 4,0
NOTE: If the “Notch Alignment” parameter is disabled, this parameter is not printed.
5. CONFIGURATION
34 VKP80II-EE
User Manual