Cushman MINUTE MISER, Руководство по ремонту и обслуживанию техника

Страница: 64 / 119

MOTOR
Page G-3
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
Install terminals and brush plate using reverse order of
removal. Install armature (commutator end) through
brush plate and press into new bearing using moderate
heat to aid installation. Position brushes against commu-
tator. Ensure the springs are seated against the rear of
the brushes and are able to move freely.
Motor Assembly
Tool List Qty. Required
Socket, 3/8", 3/8" drive................................................ 1
Torque wrench, in. lbs., 3/8" drive ............................... 1
Align the commutator end cover with the holes in the
motor housing and assemble (Ref Fig. 3 on page G-2).
Secure the commutator end cover to the motor housing
with bolts (2) and tighten to 90 in. lbs. (10 Nm) torque.
Install bearing cap (1).
Motor Tests
The field coil and motor housing are not available as indi-
vidual parts. No testing is recommended to determine the
specific area of failure. When a test of the power wiring
system indicates that the system is operating correctly
and the vehicle either does not run or runs poorly, the
motor is the only remaining component and must be
replaced.
Motor Installation
Tool List Qty. Required
Socket, 7/16", 3/8" drive .............................................. 1
Torque wrench, in. lbs., 3/8" drive ............................... 1
Be sure that a bumper spline is installed between the
motor input pinion shaft and splines. Apply a small quan-
tity of molybdenum grease to the male portion of the
spline. Carefully mate the motor spline with the input
shaft of the rear axle. Align the orientation marks and
install the mounting hardware. Tighten to 168 in. lbs. (19
Nm) torque (Ref Fig. 2 on page G-1).
Attach the four motor wires to motor (Ref Fig. 6 on page
G-3). Tighten the nuts to 66 in. lbs. (7 Nm) torque.
Fig. 4 Brush Wear
Fig. 5 Securing Brushes
.62" Min
(16 mm)
1.30"
(33 mm)
New
Brush
Worn
Brush
(Replace)
Brush
Brush
Spring
Spring Position
for Installed Brushes
Spring Position for
Removing/Replacing
Brushes
Brush
Fig. 6 Motor Wiring
Motor
Terminal
Wire
Marker
From
A1
A2
S1
S2
A1
A2
S1
S2
Controller 'B+'
Reverse Solenoid
Controller 'M1'
Controller 'A2'
MOTOR WIRING
Refer to Wiring Diagram Section 'H'