Cushman MINUTE MISER, Руководство по ремонту и обслуживанию техника

Страница: 16 / 119

GENERAL INFORMATION & ROUTINE MAINTENANCE
Page A-3
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
After the vehicle has been put into service, it is recom-
mended that the brakes be checked daily by performing
a brake test..
To prevent severe injury
or death resulting from
operating a vehicle with
improperly operating brake system, the braking sys-
tem must be properly maintained. All driving brake
tests must be done in a safe location with regard for
the safety of all personnel.
For information on conducting a brake test, refer to
BRAKES section.
TIRES
Tire condition should be inspected per the Periodic Ser-
vice Schedule (Ref Fig. 19 on page A-10). Inflation pres-
sure should be checked when the tires are cool. Be sure
to reinstall valve dust cap after checking or inflating. For
additional information, refer to WHEELS AND TIRES
section.
LIGHT BULB REPLACEMENT
To replace the headlight bulb, pivot the headlight forward
and remove the two Phillips head screws from back side
and separate light assembly. Place new bulb in place and
secure with screws previously removed.
To replace the taillight bulb, roll the rubber bezel from
around the edge of the taillight and remove lens. Replace
with new bulb.
Replacement headlight and taillight bulbs and 15 amp
fuses are available from a local distributor, an authorized
Branch or the Service Parts Department.
CARE AND CLEANING OF THE VEHICLE
When pressure washing vehicle, do not
use pressure in excess of 700 psi. To
prevent cosmetic damage, do not use any abrasive or reactive
solvents to clean plastic parts.
It is important that proper techniques and cleaning mate-
rials be used. Using excessive water pressure may
cause damage to seals, plastics, the electrical system,
body finish or back cushion material. Do not use pres-
sure in excess of 700 psi to wash vehicle.
Normal cleaning of vinyl backrests and plastic or rubber
trim requires the use of a mild soap solution applied with
a sponge or soft brush and wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require
the use of a commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive
appearance and durable protection. Frequent washing
with lukewarm or cold water is the best method of pre-
serving the painted surfaces.
Do not use hot water, strong soap or harsh chemical
detergents.
Fig. 6 Brake Bushing Lubrication
Fig. 7 Lubrication
5684
5685
! !