Cushman HAULER 1200X EFI 2019, Руководство пользователя

Страница: 51 / 72

M
AINTENANCE
49
Adjusting the Belt
1. Loosen the starter/generator pivot bolt.
2. While holding the lower adjusting nut with a wrench, loosen the upper jam nut with another wrench. Move the
lower nut up or down the adjustment bolt until the correct belt tension is achieved.
3. Hold the lower nut in place and tighten the upper jam nut against it.
4. Tighten the starter/generator pivot bolt.
AIR INTAKE AND COOLING FINS
Keep the engine cooling compo-
nents clean to reduce the risk of
overheating and the possible igni-
tion of accumulated debris.
Dirt and debris can clog the engine air cooling system. Allow
the engine to cool and use the following guidelines after
every off-road use:
• Check for a build up of dirt and debris in the air intake and
cooling fins.
• Clean the areas shown to prevent engine damage.
• Make sure the linkages, springs and controls are clean.
• Make sure the area around the muffler is free of any com-
bustible material.
Regular maintenance of the cooling system is required to ensure an adequate supply of air to the cooling fins. Com-
pressed air can be used for routine cooling system maintenance.
Clean the cooling system at the intervals indicated in the
SCHEDULED MAINTENANCE CHART on page 38.
REAR AXLE
The rear axle has an oil level check/fill plug located on the driver side at the
rear of the housing. Unless leakage of axle oil is evident, an annual check is
sufficient.
Change the axle oil at the intervals indicated in the
SCHEDULED MAINTE-
NANCE CHART on page 38. The drain plug is located at the bottom of the rear
axle housing.
Checking the Axle Oil Level
1. Clean the area around the check/fill plug.
2. Remove the plug. The correct axle oil level is just below the bottom of the
threaded hole.
3. If axle oil is low, slowly add oil with a pump until it starts to seep from the check/fill hole. Install the plug.
AIR FILTER
Inspect and replace the air filter cartridge at the intervals indi-
cated in the
SCHEDULED MAINTENANCE CHART on
page 38.
NOTICE: The filter is a dry filter. Do not apply oil.
1. Unlatch the cover to access the air filter cartridge.
2. Remove the filter from the housing.
3. Inspect the cartridge.
Using compressed air to clean the fil-
ter cartridge will damage the filter which can cause engine damage.
Tools
• Socket, 13 mm
• Ratchet
• Funnel
Drain Plug
Check/Fill Plug
Air Filter Cartridge