Cushman BELLHOP 2, Руководство пользователя и руководство по обслуживанию

Страница: 40 / 74

OPERATION AND SERVICE INFORMATION
Page 18
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
kg) tension using the same technique and inspect for
cracking or wear. A maximum deflection of 1/2" (13 mm)
is acceptable
Adjusting The Belt
Loosen the starter/generator pivot bolt.
While holding the lower adjusting nut with a wrench,
loosen the upper jam nut with another wrench. Move the
lower nut up or down the adjustment bolt until proper belt
tension is achieved. Hold the lower nut in place and
tighten the upper jam nut against it (Ref Fig. 26 on page
18).
Tighten the starter/generator pivot bolt.
BATTERY CLEANING
To reduce the possibility of damage to vehicle or floor,
neutralize acid before rinsing battery.
To reduce the possibility of damage to electrical compo-
nents while cleaning, do not use a pressure washer.
Cleaning should take place per the Periodic Service
Schedule (Ref. Periodic Service Schedule on page 13).
When cleaning the outside of the battery and terminals,
first spray with a solution of sodium bicarbonate (baking
soda) and water to neutralize any acid deposits before
rinsing with clear water.
Use of a water hose without first neutralizing any acid,
will move acid from the top of the battery to another area
of the vehicle or storage facility where it will attack the
metal structure or the concrete/asphalt floor. Additionally,
a residue will be left on the battery which is conductive
and will contribute to the discharge of the battery.
To reduce the possibility of battery explosion
that could result in severe injury or death, do
not use metallic spray wand to clean battery
and keep all smoking materials, open flame or
sparks away from the battery.
The correct cleaning technique is to spray the top and
sides of the battery with a solution of sodium bicarbonate
(baking soda) and water. This solution is best applied
with a garden type sprayer equipped with a
non metallic
spray wand or a plastic spray bottle . The solution
should consist of the amounts of sodium bicarbonate
(baking soda) and clear water shown below (Ref Fig. 27
on page 19). In addition to the battery, special attention
Fig. 24 Check Belt Tension with Gauge
Fig. 25 Check Belt Tension Manually
Fig. 26 Adjust Belt Tension
3/8" (1 cm) Maximum
Deflection (New Belt)
1/2" (1.3 cm) Maximum
Deflection (Existing Belt)