Cushman BELLHOP 2, Руководство пользователя и руководство по обслуживанию

Страница: 18 / 74

Owner’s Manual and Service Guide
Page xvi
S A F E T Y I N F O R M AT I O N
ANSI/NGCMA Z130.1-2004
5.2.2 Wet areas or icy terrain
Extreme caution should be used when driving on wet or icy terrain. Wet grassy areas or
ice may cause a golf car to lose traction and may affect operator control. Wet or icy
areas should be chained or roped off to prevent golf car operations or be identified by a
suitable warning to operators not to operate golf cars in that area.
5.2.3 Sharp turns, blind corners, bridge approaches
All turns shall be negotiated at a reduced speed. Negotiating a turn can affect the
stability and control of a golf car, causing loads and passengers to shift. Sharp turns,
blind spots, bridge approaches, and other potentially hazardous areas shall be closed
off to prevent golf car operation or shall be identified with a suitable warning to the
operator of the nature of the hazard, stating the proper precautions to be taken to avoid
the hazard.
5.2.4 Loose terrain
Extreme caution shall be used when driving in areas of loose terrain. Loose terrain, for
example, sand or gravel, can cause a golf car to lose traction and may affect stability.
Areas of loose terrain should be repaired if possible, or closed off to prevent golf car
operation, or identified by a suitable warning to operators not to operate golf cars in
those areas.
5.2.5 Golf car/pedestrian interaction areas
Areas where pedestrians and golf cars could interact should be avoided by rerouting the
golf car traffic or the pedestrian traffic. If avoidance of the interaction is not possible or
is highly impractical, signs shall be erected warning pedestrians of the golf car traffic.
Signs shall also be erected warning golf car operators of the pedestrian traffic and to
drive slowly and with caution.
6 Maintenance
6.1 Introduction
Golf cars may become hazardous if maintenance is neglected or improperly performed.
Proper maintenance facilities, trained personnel and maintenance procedures, in
accordance with the manufacturer’s recommendations, shall be provided by the
controlling party.