Curtiss-Wright Parvus SWI-22-10-01, Руководство пользователя, Страница: 19 / 107

MNL-0641-01 Rev A3 ECO-4823 Effective: 04 Oct 16 Page 19 of 107
C
HAPTER
3. H
ARDWARE
I
NSTALLATION
E
QUIPMENT
I
NSTALLATION
To use the SWI-22-10-xx in a lab environment, you must have:

Appropriate cables, such as the CBL-SWI-22-10-10 Breakout Cable Set

A power source, either:

A PCI/104 stack or a PCI/104-Express stack

+5VDC@3A supplied to the SWI-22-10 board (connected at P3). A power cable is included
with the Breakout Cable Set.

Thermal cooling, either:

SWI-22-10 Thermal Plate factory-installed on the SWI-22-10-10T or the SWI-22-10-01T

A custom cooling solution (a small fan blowing across the top of the board will do).

A host PC with a free RS-232 port and/or an Ethernet port
. See “Serial CLI Setup” and “Using the
Web GUI” in chapter four to setup the serial and Ethernet ports on the host PC.
I
NSTALLATION
P
RECAUTIONS
ESD Warning!
This product uses components that can be damaged by electrostatic discharge (ESD). Observe
precautions for handling electrostatic-discharge sensitive devices.
Exercise extreme caution when installing or removing the board. The interface pins are very
easily bent.

Ensure proper line-up with receptacles before applying force.

Apply force as evenly as possible to prevent the interface pins from inserting at an angle.

If the stack requires disassembly, apply even force while disassembling components.