23 of 37
STEP 19: Heater Hose Install
19.9
Remove plug from the water pump and insert straight
fitting (from cab hardware kit) shown in Figure 19.9 into
right engine tie in (return). Use pipe thread sealant.
19.10 Use hose clamps to fasten heater hoses to both left
and right fittings.
19.11 Route hoses back along the sides of the motor and
over to the bottom of the right side frame. Be sure to
avoid all moving and hot components.
19.12 Reconnect fuel filter mount, the air hose, black reserve
tank, and the guard removed in steps 19.5, 19.6, 19.7,
and 19.8.
19.13 With hoses properly routed so there are no kinks, cut to
the appropriate length and connect to the elbows under
the right floorboard using hose clamps. See Figure
19.13. Note: the elbows can be rotated to achieve
ideal routing.
19.14 Re-fill coolant system.
19.15 Turn engine on and check for leaks.
19.16 Check to make sure heater hoses get warm.
19.17 Allow engine to cool completely and top off coolant.
STEP 20: Miscellaneous
20.1
Fill washer bottle through exterior cover plate on right
side frame.
20.2
Re-install the SMV sign onto the tab at the bottom of
the left side frame.
20.3
Re-install the directional to the tabs on the outside of
the side frames. Connect the supplied 8” extension
harness to the light and connect the open end to the
main tractor harness.
20.4
If the tractor had optional rear work lights installed, re-
install on the tabs on the outside of the side frames.
20.5
Secure any extra wiring that may be dangling.
Figure 19.9 Heater Return Fitting
INSTALLATION
Figure 19.13 Connect Elbow Fittings
