22 of 37
STEP 19: Heater Hose Install
19.1
Raise the front loader bucket up and set the cylinder
safety lock.
19.2
Install corrugated split-loom onto heater hoses.
19.3
With engine cold, open the hood, remove engine side
shrouds, and drain the coolant from the radiator.
19.4
Remove plug and insert the supplied 90° fitting shown
in Figure 19.4 into left engine tie in (supply). Use pipe
thread sealant. Rotate the fitting so that the hose barb
is aiming towards the rear of the tractor.
19.5
Remove the two bolts holding the guard in place on the
right side of the motor and remove the guard as shown
in Figure 19.5. Save for re-use.
19.6
Remove the two bolts holding the black reserve tank
and save for reuse as shown in Figure 19.6.
19.7
Remove the 90 degree air hose shown in Figure 19.6.
19.8
Remove the three bolts securing the fuel filter mounting
bracket
and save for reuse as shown in Figure 19.8.
Pivot the fuel filter out of the way to access the plug on
the side of the water pump.
Figure 19.4 Heater Supply Fitting
Figure 19.5 Remove Guard
Figure 19.6 Heater Hose Connection
INSTALLATION
Figure 19.8 Remove Filter Mounting Bracket
Remove 2
Bolts
Remove 2
Bolts
Remove Air
Hose
Remove 3
Bolts
