Curtis DYNA-FOG DYNA-JET L30 2 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 51

OFF
ON
SYSTEM MASTER PUMP CALIBRATE
ON
PUMP BOX
DETAIL “A”
PUMP BOX
FUSE BLOCK
Protective devices like Fuses and Circuit Breakers are included to protect against short-circuits
and/or overload currents. The general idea of the fuse is that it melts a conductive link when
current gets higher than its rating and thus stops the current flowing.
The Circuit Breaker is a thermal device used in
the motor distribution system for protecting
against overload and short-circuits in the system.
The circuit breaker has a "switch" on it which
opens once the current exceeds its rating. It has a
time delay effect with brief over-current conditions
(common in motor start up).
Automatic reset circuit breakers will recycle
continuously during an over-current condition.
The composite alloy material will deflect and
separate the contacts when an over-current
situation occurs and return to the run mode as it
cools. The process will continue until the source
of the over-current is removed or corrected.
CAUTION: Each Red Fuse is rated for 10 Amps; do not replace it for one of higher rating. Each
Circuit Breaker is rated for 25 Amps. Do not replace it for one of higher rating.
If a fuse blows, or if the circuit breaker opens the circuit, it means that a short-circuit and/or
overload situation was present, and a detailed inspection is required to define the condition or
fault which caused the protective device to activate.
25 AMP CIRCUIT BREAKER
BLOWER/FAN
FOR CALIBRATE
FUNCTION
PUMP
SYSTEM MASTER
VOLT/HOUR METER
10 AMP FUSE
PUMP
RELAYS
ACTUATOR
10 AMP FUSE
(3) 25 AMP CIRCUIT
MOTOR CONTROL
BREAKER ATOMIZER
FUSE
P/N 65303
CIRCUIT BREAKER
P/N 65286
DETAIL “A”
45