CAB INSTALLATION
6 of 28
STEP 2: (REAR MOUNT BRACKETS)
2.1
Using the fasteners listed below and those that were
removed during step 1.4, first install the spacers and
then the rear mount bracket on the left side of vehicle
with the small flange facing up. See Figure 2.1.
Hardware Used
Qty
1/2”
ID X
3/4”
OD X
5/32”
THK Spacer
2
Tools required
17mm Wrench or Socket
2.2
Install lower left mount per Figure 2.2.
Hardware Used
Qty
5/16
-
18 X 3/4 Hex Head Screw
2
5/16
-
18 Hex Nut
2
Tools required
1/2”
Wrench and Socket
2.3
Install left tail light on rear mount bracket, removed
during step 1.5. See Figure 2.3.
Tools required
17mm Wrench
2.4
Repeat steps 2.1 thru 2.3 on the right side of the
vehicle.
Fig. 2.1 (Rear Mount Bracket Orientation)
Fig. 2.2 (Lower Rear Mount Orientation)
Fig. 2.3 (Re
-
Install Tail Light)
Note: Red on back
lower half of tail light.
STEP 3: (ROPS BRACKETS AND
CLAMPS)
3.1
Measure down from the tab found on the ROPS
Structure approximately
7/8”.
Make a mark using a
china marker or other non
-
permanent marker. Install the
left ROPS bracket and clamp. See Figure 3.1.
Hardware Used
Qty
5/16
-
18 X 3/4 Hex Head Screw
4
5/16
-
18 Hex Nut
4
Tools required
1/2”
Wrench and Socket
3.2
Repeat step 3.1 on the right side of the vehicle.
Fig. 3.1 (ROPS Bracket and clamp, left)
ROPS Tab
7/8”
