CAB INSTALLATION
23 of 34
STEP 2: (CAB INSTALLATION)
2.34
Per Figure 2.34, tighten hardware clamping the
right fender. Making sure retainer sits in groove
found in fender. Note: 5/16
-
18 screw may need to
be adjusted so compressor shroud has proper fit
with bracket.
Tools required
13mm wrench and socket
1/2”
wrench or socket (if needed)
2.35
Using a narrow plastic putty knife, push bulb
rubber down in areas between the side frame and
the vehicle
’
s fender where gaps occur. If there are
still gaps, cut 1/2" X 9/16" rubber foam (into
2”
pieces) and install into any gaps that may be
found between the left side of the cab and fender.
On the right side, at the corner of the side frame
and rear filler, as well as near the floorboard.
Make sure to apply adhesive side onto the fenders
of the vehicle. Per Figures 2.35a and b.
Tools required
Scissors
Narrow Plastic Putty Knife
2.36
Per Figure 2.36a, re
-
install the left and right doors.
Next, install gas shocks onto the doors and side
frames as shown on figure 2.36b. Making sure
rod side gas shock is on the door side.
Fig. 2.34 (Tighten Hardware to Clamp Fender)
Tighten
Retainer
5/16”
Screw
Bracket
Fig. 2.36a (Re
-
Install Door, Left)
Fig. 2.36b (Install Door Gas Shock, Right)
Gas Shock
Fig. 2.35a (Install Foam on Left Fender)
Fig. 2.35b (Install Foam on Right Fender)
Install
Foam Here
As Needed
Install
Foam Here
As Needed
Gas Shock Rod
