Cumberland
1004 E. Illinois St.
Assumption, IL 62510
PHONE 1-217-226-4421
FAX 1-217-226-4420
Part No. 4801-3006 Rev 1-15 Mega Flow Cone Fan
– Unassembled 11 of 15
7.
Cone Assembly and Mounting Instructions
Cone Assembly Steps
a.
Stand cone panels on edge with large end to ground as shown in
Figure 9
.
b.
Slip four (4) cone panels together using tab and slot connections on edges of each panel.
IMPORTANT:
All tabs must be on the inside of the cone assembly. The pilot holes and etched
numbers (orientation indicators) must be located at the top and outside of the cone.
c.
Place bolts through holes and thread nuts into place to hold four (4) cone panels together. Nuts must be located
on the outside of the cone assembly. Do not tighten nuts. Refer to
Figures 9 & 10
.
d.
Once four (4) cone panels are assembled stand assembly up on large radius side. Refer to
Figure 7
.
e.
Pull both ends together creating a heart shape as shown in
Figure 9
.
f.
Place remaining bolts through holes and thread remaining nuts into place to hold cone together.
Nuts must be located on the outside of the cone assembly. Do not tighten nuts. Nuts to be
tightened after cone mounted on fan. Refer to
Figure 10
.
Figure 7: Fan Cone Panels
Figure 8: Cone Orientation Indicators
Slits for Collapsible Side
Panel 54” Cone Only
IMPORTANT
All pilot holes and
etched numbers must
be located at top &
outside of cone
Nuts on
the
Outside
