Cumberland EDGE 074-11793, Схема подключения

Страница: 60 / 82

Chapter 3: Basic Connections
NOTICE
The recommended installation wire gauge is 16 AWG (diameter of 1.29mm or
cross sectional area of 1.30mm
2 ) for the power supply wires at a length of 300
meters (1000 feet). The recommended installation wire gauge is 18 AWG
(diameter of 1.02mm or cross sectional area of 0.82mm
2 ) for the communication
wires at a length of 1200 meters (4000 feet). The cable must be twisted pair and shielded.
WARNING
Installation must only be performed by qualified service personnel.
NOTICE
For the small terminal blocks used for inputs and low voltage outputs, use a
tightening torque from 0.5N*m (4.43lbf*in) to 0.6 N*m (5.2lbf*in) to fasten a wire.
The communication network must be installed in a daisy chain topology. The order of the wires is
very important. At both ends of network, the End-of-Line must be activated. If the wiring can’t be
done in a single chain, you might need to deactivate the end-of-line (EOL) resistor to improve com-
munication. AP/Cumberland does not warranty the proper operation if the topology network is not
daisy chain.
60 891–00516 EDGE Wiring Diagram