Cumberland Competitor PNEG-1559, Инструкция по установке и эксплуатации

Страница: 14 / 38

3. Installation and Assembly
14 PNEG-1559 Competitor Series - Fiberglass Fans
Cone and Grill Guard Assembly (54" Fan Model)
1. Assemble the four (4) cone panels using the hardware provided (use cone/guard hardware kit).
(See Figure 3C.) Overlap the cone panels and line up the slots on the flanges. Bolt together
outside portion of cone using one 5/16" x 1" SS flange bolt, one 5/16" SS flange nut and two (2)
5/16" x 1-1/2" fender washers per hole. Only install hardware in outside two (2) rows of holes. Use
washers on both sides to prevent cracking fiberglass panels.
2. When complete, the cone assembly should look like the cone in Figure 3D . Once assembled, position
cone assembly outside the building and lift into position onto the fan housing. Push completely onto
orifice and line up the inner holes of the orifice with the holes of the cone.
Bolt the cone to the housing orifice using eight (8) 5/16" SS flange bolts, eight (8) 5/16" flange nuts
and sixteen (16) 5/16" x 1-1/2" fender washers. Insert bolts from the inside of orifice through the cone
as shown in
Figure 3E below. Tighten all bolts and nuts securely.
3. Insert the grill guard inside of the cone, push back towards the prop until the grill fits snug against the
inner portion of the cone. Using the eyelets of the grill guard as the template, mark four (4) locations
through the eyelets.
4. Drill through the marks with a 5/16" drill bit. Re-install the grill and bolt securely using four (4)
5/16" x 1" SS flange bolts, four (4) 5/16" SS flange nuts and eight (8) 5/16" x 1-1/4" fender washers.
The fan is now ready to wire up to the power source.
Figure 3C Figure 3D
Figure 3E