Super Saver Bunsen Jet Brooder with SPI
8
3.
Place ceramic element on top of the support ring.
4.
Insert the suspension rods through the three slotted openings in the canopy. Insert a
cotter pin through the second and smaller opening in each of the suspension rods,
then bend the longer leg of the cotter pin to the side. The pilot assembly should be
aligned with the burner unit assembly, when facing the gas valve.
5.
Insert thermostat bulb through one retaining clamp, then through the holes provided
in the gas valve bracket as shown in Fig. 5. Place the other retaining clamp over end
of the thermostat bulb.
6. Insert thermocouple into holes in pilot bracket, push through hole until held in place
by springs. See Figure 6. Take the opposite end of the thermocouple and thread into
the gas valve’s thermocouple port. See illustration on previous page
.
5.6.
Gas Tubing Assembly
1.
Refer to Figure 6 for gas tube assembly.
2.
Thread orifice into lower portion of the burner. Use caution to keep the orifice
bracket from becoming misaligned while tightening the orifice. Misalignment will
cause poor operation.
3.
Remove brass nut and ferrule from brass fitting located in the gas outlet port (see
illustration on previous page for location of gas outlet port), slide the brass nut and
ferrule over the gas tubing, insert the tubing into the brass fitting, and tighten the
brass nut.
4.
Remove the brass nut and ferrule from orifice. Slide brass nut and ferrule over the
gas tubing, insert the tubing into the orifice, and tighten the brass nut.
5.
Loosen brass fitting that is threaded into pilot outlet of the gas valve. Insert pilot
tubing into brass fitting, then tighten.
6.
Remove ferrule and compression fitting from pilot.
7.
Slide ferrule and compression fitting onto tubing.
8.
Push pilot onto tubing and tighten compression nut.
9.
Push pilot through hole in pilot bracket and secure with brass nut.
10.
Latch pilot cover over pilot.
Figure 6
Pilot Assembly
Pilot Bracket
Pilot orifice
Brass Nut
Pilot Cover
Compression
Nut/Ferrule
Gas tubing
Opening For
Thermocouple
Pilot bracket
