Culligan Gold 10", Руководство пользователя

Страница: 9 / 39

9
01018854 E 05/19
Component
Description
The water softener is shipped from the factory in a minimum of three cartons.
Remove all components from their cartons and inspect them before starting installation.
Control Valve Assembly - Includes the regeneration control valve and the Accusoft® Plus circuit board.
Small parts packages will contain additional installation hardware, and the Softener Owner’s Guide.
Media Tank
- Includes Quadra-Hull™ media tank complete with Cullex® ion exchange resin,
underbedding and outlet manifold (12” and 14” tanks are shipped without media).
Salt Storage Tank Assembly - Includes salt storage container with support plate and Dubl-Safe™
brine refill valve and chamber.
Bypass Valve - Includes the molded bypass valve, the interconnecting couplings, and the assembly pins.
Refer to Figure 1 for system placement.
• Set the media tank on a solid, level surface near water, drain and electrical facilities.
• Set the brine system on a flat, smooth, solid surface as near the media tank as possible.
Tank Assembly
• 9” and 10” tanks are filled with media at the factory.
• Before the unit can be connected to the plumbing the manifold must be inserted and media
loaded into the tank for 12” and 14” units.
CAUTION! Do not lay the tank down unless a suitable lifting device is available.
Personal injury and damage to the unit can result if dropped.
Position the Mineral Tank(s)
Determine the location for the mineral tanks(s) prior to loading, since they will be difficult to move
after the underbedding and gravel are loaded.
NOTE: Air gap = 2x pipe diameter or 1 inch diameter, whichever is larger.
Figure 1. Positioning the Tank