Culina ICONCER60RF, Инструкция по эксплуатации

Страница: 14 / 29

Controlling the cooker hood remotely
I
MPORTANT: This section is only applicable if you have
purchased the optional.Cooker Hood Model:ICONCG60RF
Before First Use
This cooker hood model ICONCG60RF and the
ceramic
hob model
ICON
C
ER60RF must be paired by radio frequency before remote control
can occur. This only needs to be done once.
When connected the power output of the
ceramic
hob will control the
extraction rate of the cooker hood.
To Set Up Connectivity
1.Make sure that the hob and the hood are switched off.
2.Press the Timer icon and Light icon together on the control panel.
The LED display will alternately flash red and white.
3.Turn on the hob and make sure the connectivity indicator is lit red.
Note: Simultaneously press the "-" key and the "+" key on the hob if it is
not lit.
4
.
Press the keys and together on the hob and the connection
indicator will flash to confirm connection.
5.The control panel of the hood will show A for five seconds to indicate
connectivity has been
made with the hob.
6.Press the keys and together on the hob one more time to store the
connectivity settings.
I
MPORTANT :The connectivity operation above must be completed
within two minutes of turning on the power to the hood. If this is not
successful, switch off both the hood and the hob, wait for one minute
and attempt the connectivity again.
Using the connectivity function
1
.
Ensure the connectivity indicator is lit on the hob control panel.
2
.
The extraction rate of the hood will vary based upon the total power
output selected on the hob,as shown in the table. Each hob cooking
zone has a maximum rated output of 10 comprising 1-9.
14