2
3
SPECIAL CORD SET
INSTRUCTIONS
A short power-supply cord is provided to
reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
Longer extension cords are available and
may be used if care is exercised in their use.
If a long extension cord is used, the marked
electrical rating of the extension cord must
be at least as great as the electrical rating of
the appliance. The extension cord should be
a grounding-type 3-wire cord, and the
longer cord should be arranged so that it will
not drape over the countertop or tabletop
where it can be pulled on by children or
tripped over.
NOTICE
If you have a diecast metal unit, for your
protection, it is equipped with a 3-conductor
cord set that has a molded 3-prong
grounding-type plug, and should be used in
combination with a properly connected
grounding-type outlet as shown in Figure A.
IMPORTANT UNPACKING
INSTRUCTIONS
1. Place the box on a large, sturdy, flat
surface.
2. Remove the instruction book and any
other literature.
3. Turn the box so that the backside of the
Brewer is down and slide the
coffeemaker from the box.
4. After the Brewer has been removed,
place the box out of the way and take
the packing materials away.
5. Remove the polybag covering the Brewer.
We suggest you save all packing materials
in the event that future shipping of the
machine is needed. Keep all plastic bags
away from children.
IMPORTANT
SAfEGUARDS
When using electrical appliances, basic
safety precautions should always be
followed to reduce the risk of fire, electric
shock and/or injury to persons, including the
following:
1.
READ ALL INSTRUCTIONS.
2. Do not touch hot surfaces. Use handles
and knobs.
3. To protect against electric shock, do not
place cord, plug, or base unit in water or
other liquids.
4. Close supervision is necessary when
any appliance is used by or near
children.
5. Always unplug from outlet when not in
use and before cleaning. Allow to cool
before putting on or taking off parts and
before cleaning the appliance.
6. Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
dropped or damaged in any manner.
7. The use of accessory attachments not
recommended by Cuisinart may cause
injuries, fire, electric shock or injury to
persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table
or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or
electric burner, or in a heated oven.
11. Always fill water reservoir first, then plug
cord into the wall outlet. To disconnect,
turn controls to Off, then remove plug
from wall outlet.
12. Do not use appliance for other than
intended use.
13. Do not lift handle to open the lid of the
brewer while brewing is in progress.
14. Do not overfill the water reservoir with
water. Use
ONLy wATER
in this
appliance! Do not put any other liquids
or foods in the water reservoir except as
instructed in the cleaning instructions in
this guide.
15. Do not clean drip tray with cleansers,
steel wool pads, or other abrasive
materials.
16.
wARNING: TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK, DO NOT
REMOVE THE BASE PANEL. NO
USER-SERVICEABLE PARTS ARE
INSIDE. REPAIR SHOULD BE DONE
ONLy By AUTHORIZED PERSONNEL.
SAVE THESE
INSTRUCTIONS.
fOR HOUSEHOLD
USE ONLY
WARNING: RISK Of fIRE OR ELECTRIC SHOCK
The lightning flash with arrowhead symbol within an equilateral triangle is intended
to alert the user to the presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude to constitute a risk of fire
or electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
wARNING
RISK Of fIRE OR ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK Of fIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY
A.
Circuit Grounding
Conductor
Connected
Properly
Grounding
Prong