10
Problem: The used capsule will not fall
into the capsule container.
Solution:
• That indicates the capsule container is
full. Empty the capsule container and
then try again, or manually remove the
used capsule in the brew head.
Problem: I want to reset the coffee
programming.
Solution:
• See pages 6 and 7 for instructions.
Problem: The controls lights are not as
bright as they were.
Solution:
• The machine has an energy-saving
feature that dims the lights and power by
about 50% after 30 minutes of non-use.
Restore full power by pressing any
button.
Problem: Machine turned off.
Solution:
• The machine’s auto-off feature turns
the coffeemaker off after 60 minutes of
non-use.
Problem: Coffee is too hot.
Solution:
•
Press the
HOT
button and wait until
the light is steady.
Problem: Coffee is not hot enough.
Solution:
• Press the
HOTTER SETTING
button
and wait until the light is steady.
• If still not hot enough at hotter setting:
with no capsule in the brew head, use
the manual button to despense a cup
of water to pre-heat, then make your
espresso as indicated on page 6.
Problem: SHORT
/LONG
buttons
flash quickly; all buttons are
non-functional; or some buttons
are off.
Solution:
• Indicates the coffee boiler detects low or
high temperature. Recover the unit by
unplugging it and let the unit cool down
for approximately 10 minutes.
Problem: CAPPUCCINO
/LATTE
buttons flash quickly; all other
buttons are off; or all buttons are
non-functional.
Solution:
• The steam boiler detects low or high
temperature. Recover the unit by
unplugging it and let the unit cool down
for approximately 10 minutes.
Problem: Short
/Long
Manual/
Steam
buttons flash.
Solution:
•
Refill the water reservoir or make sure it
is properly engaged on the base.
Problem: Steam /Cappuccino
/Latte
buttons are non-functional
or off.
Solution:
•
Install or properly engage the milk tank
with no capsule in the brew head.
Problem: While using Steam setting;
steaming stopped before pushing
button.
Solution:
• There is a safety auto-shut off switch to
stop steaming after 35 seconds. Press
steam again for additional cycle, if
necessary.
Problem:
No milk is dispensing when using
steam
/ Cappuccino
/
Latte buttons.
Solution:
• Properly install tubing by connecting
short side to clear silicone outlet, and
long side in black outlet.
