3
HOW TO USE YOUR
DRINK MIXER
1. Clean the drink mixer thoroughly before
initial use.
2. Use the control switch to turn the unit off (O) or
to select either low (I) or high (II) speed. Always
set the control switch to off (O) before plugging
in the mixer.
3. Plug the drink mixer into a properly
grounded outlet.
4. Put recipe ingredients into the mixing cup.
(Do not fill beyond the top fill mark on the side
of the mixing cup, which represents 1¾ cups
[420 ml]). This will help to prevent the mixture
from splashing out during mixing.
5. Attach the mixing cup to the drink mixer by
sliding the lip of the mixing cup up under the
cup holder and setting the bottom edge of the
mixing cup on the cup rest.
6. Operate the drink mixer only when the mixing
cup is attached.
7. Set the control switch to low speed and mix for
3 seconds. If your recipe requires high speed,
switch to high speed after mixing 3 seconds on
low speed; otherwise, continue on low speed
until finished.
8. When mixing is complete, always set the
control switch to off (O) before removing the
mixing cup.
Operating Cycle: 3 min. ON / 1 min. OFF
CLEANING
1. Not for water jet cleaning.
2. Clean the drink mixer before initial use, and
immediately after each use.
3. Clean the spindle, agitator, and mixing cup by
filling the mixing cup to the top fill mark with
warm, soapy water. Attach the mixing cup to
the drink mixer and run it on low speed for
about 30 seconds. Turn the unit off (O), empty
the mixing cup, and repeat with rinse water.
Turn the unit off (O) again, empty the
mixing cup, and allow it to dry.
4. Unplug the drink mixer before cleaning the
outside of the unit.
5. Clean the outside of the unit by using a cloth
moistened with a mild soap and water solution.
Rinse the cloth and wipe the unit again.
Prevent liquid from running into the housing
by wringing all excess moisture from the cloth
before using it. Wipe the housing dry after
rinsing.
Do not immerse the unit in water or
any other liquids.
MAINTENANCE
MOTOR: The motor requires no greasing or
oiling. Sealed-in lubrication gives the unit lifetime,
smooth operation.
HELPFUL HINTS
1. Always be sure the control switch is in the off
(O) position before plugging in the drink mixer
and before removing the mixing cup when
mixing has been completed.
2. For best mixing results, add wet recipe
ingredients to the mixing cup before dry recipe
ingredients.
3. The mixing times of beverages containing ice
cream-type ingredients will vary according
to the hardness of the ingredients. Softer
ingredients work better.
4. If your recipe calls for ice, use only crushed ice
in the drink mixer.
5. Do not mix hot ingredients with your drink
mixer.
6. Operate the drink mixer only when the cup is
attached.
7. In general, start mixing on low speed for about
3 seconds. Finish mixing on low speed if all
your ingredients are liquid, to avoid splashing.
If your recipe includes solid ingredients (ice
cream, powdered milk, etc.) or if you need
to whip cream or aerate eggs, switch to high
speed after the first 3 seconds of mixing on low
speed, and continue on high speed until mixing
is completed.
