User Manual Wireless IR Control Panels
www.cuesystem.com
Page 8 of 26
5.
Button Labels
5.1.
irCUE 99 .....................................................................
The panel uses one big label foil for all buttons.
Steps
1. Use AutoCAD file named
CS0149.0001.3-Foil.dwg
for preparation of a layout. This file is
available on www.cuesystem.com. The foil shape is described on the picture below.
2. Print the foil on a standard printer.
3. Cut the foil into a shape according the picture (see above).
4. Put the panel upside down.
5. Unscrew two screws from the rear side of the panel.
6. Remove the front panel with buttons and foil
still holding it upside down
.
7. Replace the foil.
8. Put the front panel back.
9. Fasten the screws.
5.2.
irCUE ..........................................................................
The separate labels for each button can be printed on a standard printer. Dimension of the label are
•
6.5 mm x 12 mm for normal button
•
6.5 mm x 29 mm for double button.
It is necessary to disassembly the control panel to change a label.
Steps are
1. Put the control panel on a table face down.
2. Unscrew the screws.
3. Dismount the bottom of the control panel with electronic board.
4. Install new labels to all buttons.
5. Assembly the control panel.
