CuddeLink
Manual
Version 2.20.2017
Page 7 of 24
50, 100,
250
will be queued to send. Deletes the oldest images to make
room for the newest.
CL LEVEL
Signal
level
X
Remote only. Use this to verify the camera is on the
network and how strong the signal is.
CL NODES
Camera
Status
X
Home only. Displays the status of each remote camera.
Step 1. Program CuddeLink CL MODE
All CuddeLink settings are in the CL MENU in the COMMANDS menu. To access the CL MENU
navigate to the COMMANDS menu and press MORE until CL MENU is displayed, then press UP.
CL MODE is used to select the camera’s CuddeLink mode. Choices are OFF, HOME, REMOTE,
REPEATER. Press UP or DOWN to select, then press MORE to continue programming additional
CuddeLink settings.
OFF – use this if you do not want this camera to be part of a CuddeLink network. The
CuddeLink radio will be disabled.
HOME – Set Home on the camera that collects images. Only 1 camera can be set to
HOME.
REMOTE – Set Remote on the cameras that take pictures and transmit the pictures to the
HOME camera.
REPEATER – use this when you need a repeater to transmit images, but you do not want
the camera to record images. Refer to REPEATER section latter in this manual.
Step 2. Program CL LOC
CL LOCATION (CL LOC) assigns a unique number to each camera on the network. It is
important that each camera on your CuddeLink networks has a unique CL LOC number. Refer to
section
CAMERA NAMING
for our recommendations on how to use this setting.
Step 3. Program CL CHAN
