CUB CRAFTERS
SECTION 9.2
CC11-100
SUPPLEMENT- SINGLE PLACE CONVERSION
Issued: 04/15/09
REPORT SC10000AFM
Date of Revision:
10/31/11
Page Number: 9-2-5
9.2.3 CONVERSION PROCEDURES
9.2.3.1 FROM TWO PLACE TO SINGLE PLACE
Remove or stow the rear seat. See Section 9.2.3.4..
Remove the rear stick and install the rear stick stub
cover. Install placard on the instrument panel, overhead
tube near the compass correction card, or in another
conspicuous place. The maximum empty weight in this
configuration is shown in Section 9.2.2.2.
9.2.3.2 FROM SINGLE PLACE TO TWO PLACE
Install rear seat. Remove the rear stick stub cover and
install rear stick (if desired). Remove the placard
governing single place operation only. The aircraft
maximum empty weight configuration is shown in Section
9.2.2.2.
9.2.3.3 DETERMINATION OF LOADING CHANGE
Use the table below to determine the weight and balance
changes for converting a two place to a single place
aircraft. Use the information in reverse when the aircraft
is returned to service in a two place configuration. Use
only the applicable information (stowing vs. removing
seat).
Item
Weight
(lb)
Arm
(in)
Moment
(in-lbs)
Rear Seat Removal (includes
seat cross bar)
-6.15
96.08
-590.89
Rear Control Stick Removal
-.20
84.08
-16.82
Rear Control Stick Cover
.69
84.08
58.02
Table 9-2-2 - Weight & Balance Changes