
CUB CRAFTERS
SECTION 9.2
CC11-100
SUPPLEMENT- SINGLE PLACE CONVERSION
Issued: 04/15/09
REPORT SC10000AFM
Date of Revision:
10/31/11
Page Number: 9-2-3
9.2.1 GENERAL
This supplement describes the process and requirements
for converting a two place aircraft to a single place
aircraft and provides authorization to perform this
conversion. In accordance with ASTM and FAA
regulations, a two place 80hp S-LSA must weigh less
than 902 pounds empty. The empty weight of 1090
pounds (1200 on floats with CC340) applies when the
aircraft has been converted to single place only
operation. The aircraft may be converted back and forth
from single place to a two place configuration as
described in this supplement, as long as it meets the
empty weight requirements for that configuration per
Section 9.2.2.2. This may be useful for owners/operators
to install special equipment such as large tires, skis, etc
but would put them overweight for two place operation.
This supplement allows that aircraft to be converted to
single place. This supplement supersedes the Pilot’s
Operating Handbook and is required for single place
operation. This conversion is considered an
owner/operator task.
9.2.2 LIMITATIONS
9.2.2.1 GENERAL
The conversion requires the following items:
For Single Place Operation:
Rear seat must be removed or stowed
Rear control stick must be removed
Rear control stick cover must be installed
Single Seat Placard must be installed
Maximum empty weight per Section 9.2.2.2.