Cub Cadet CSV240, Руководство оператора

Страница: 8 / 24

8
• Engines with primer:
Prime engine as instructed in separate engine
manual.
• The throttle control lever is located on the engine.
Move engine throttle control lever to FAST or
START position.
• Place one foot on the left rear wheel to prevent the
unit from skidding while starting.
• Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope
will pull slightly harder at this point).
NOTE: A noise will be heard when at the start of the
compression cycle. This noise should be expected until
the impeller reaches full speed.
• Pull rope with a rapid, continuous, full arm stroke.
Keep a firm grip on starter handle. Let rope rewind
slowly.
• Repeat the previous steps until engine fires. When
engine starts, move choke control (if equipped)
gradually to RUN position.
WARNING: Keep bystanders, helpers,
pets, and children at least 75 feet from the
machine before starting and while
operating. Do not operate this machine
unless the discharge chute and bag have
been properly installed and secured to the
machine.
To Empty Bag
The bag is designed to be emptied without being
removed from unit. Open the large zipper in the rear of
the bag to empty the contents. If bag is removed for any
reason, follow the instructions for attaching the bag in
the ASSEMBLY section. Be certain the zipper is closed
completely when operating the unit.
To Engage Drive
To engage the wheel drive, hold the drive clutch control
against the upper handle. Releasing the drive clutch
control stops the rear wheels from driving. Release the
drive clutch control to slow down when negotiating an
obstacle, making a turn, or stopping. Engage control
slowly to prevent the front wheels from lifting up.
Using the Chipper Shredder Vacuum
Place both hands on top of upper handle to push unit
over yard waste. Yard waste such as leaves and pine
needles can be vacuumed up through the nozzle for
shredding. After material has been shredded by the
blades on the impeller assembly, it will be discharged
into catcher bag. Do not attempt to shred or chip any
material other than vegetation found in a normal yard
(i.e. branches, leaves, twigs, etc.) Avoid fibrous plants
such as tomato vines until they are thoroughly dried
out. Materials such as stalks or heavy branches up to 2”
in diameter may be fed into the chipper chute.
See Figure 6.
WARNING: Do not attempt to shred, chip,
or vacuum any material larger than
specified on the machine or in this
manual. Personal injury or damage to the
machine could result.
Figure 6
IMPORTANT:
The flail screen is located inside the
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
MAINTAINING YOUR CHIPPER SHREDDER
VACUUM. For best performance, it is also important to
keep the chipper blade sharp.
Tire Pressure
(Pneumatic Tires Only)
WARNING: Maximum tire pressure under
any circumstance is 30 psi. Equal tire
pressure should be maintained at all
times.