CTD N80X, Инструкция по эксплуатации и руководство по техническому обслуживанию

Страница: 3 / 26

Electrical Requirements: Based on two motors per machine
Motor Load Amperes
Model No. Motor Size RPM 230 Volt 440 Volt
N80X 2 H.P., 3 Phase 3450 5.4 amps 2.7 amps
N80X 2 H.P. 1 Phase 3450 12.5 amps N/A
N80X 3 H.P., 3 Phase 3450 8.6 amps 4.3 amps
N90X 3 H.P., 3 Phase 1725 7.4 amps 3.7 amps
N90X 5 H.P., 3 Phase 1725 13.2 amps 6.6 amps
Pneumatic Requirements:
1 CFM per 10 strokes at 75 PSI (.043 cubic meters at 5.4 kg/cm2)
Dust Collection Requirements: 1200 CFM at 6” outlet
Cutting Tool Requirements: Heavy, rigid plate blades
13” blades: .110 to .120 plate; 16” blades: .120 to .130 plate; 18” blades: .130 to .140 plate
Installation and Set Up:
The Model N80X uses two 2 H.P. 3 Phase, 3450 RPM, 60 Hz TEFC Motors on a NEMA 56 Frame.
The Model N90X uses two 3 H.P. 3 Phase, 1725 RPM, 60 Hz TEFC Motors on a NEMA 182T Frame.
A disconnect switch is provided and the machine should be disconnected before blades are mounted, or at any time the
machine is serviced, or the blade is exposed. For motor protection against voltage fluctuations, a Dual Magnetic Starter
is provided as a standard feature. This starter protects the motor from overheating and will not allow the motor to
restart by itself after power outages. In addition, there is a safety interlock switch located under the blade guard. If the
blade is not locked down or in place, the machine will not start.
Space Requirements:
N80X N90X
-3-
IMPORTANT : Before operating saw, please be sure to read the “SAFETY INSTRUCTIONS TO THE
OPERATOR” (on Page No. 12).
Note: The floor stand must be shimmed, leveled and bolted to the floor or framed in to eliminate vibration.
Use holes provided in bottom of floor stand. All machines have been completely assembled at the factory,
then disassembled for shipment.