CTD CM325R, Инструкция по эксплуатации и руководство по техническому обслуживанию, Страница: 13 / 34

Sawblade Lubrication System:
The Sawblade Lubrication System is used when cutting aluminum or other non-ferrous materials. This system
normally uses a Water Soluble Oil mixture of
10 parts water to one part oil
. The system operates by syphoning
the lubrication up the line to the spray nozzle. Any air leak will cause inconsistent fluid flow to the spray nozzle.
BE SURE
your fluid is free from chips and other debris. A fluid container supplied with the machine contains
a One-Way Check Valve, Part No. B3P96, at the end of the clear fluid line. This check valve helps to hold the
lubrication in the line. However, after a couple of minutes, the lubrication or oil will back-flow into the container.
Priming of the system may be necessary if the machine has been standing without use. The system may be shut
off by closing the toggle valve next to the vacuum pump. The fluid must be clean or the Vacuum Pump will clog.
CTD Bio Lubrication System:
The CTD biodegradable lubrication system operates by pulse spraying a minute amount of biodegradable
lubricant directly on to the saw teeth of the blade in time-measured increments. The majority of the lubricant
then dissipates with the heat of the cutting action. Chips coming off the blade are hot and dry, and are more
easily collected. (See specific instructions included with system.)
-11-
Combination Blades:
Any combination blade is basically an aluminum cutting blade. Significant blade life in between sharpenings
will be lost if a blade is used for cutting both aluminum and wood. The amount of production for either wood
or aluminum should be the determining factor in the assessment of the particular blade type to be used.
Please consult factory.
Sound Levels:
During normal running of the machine without cutting, the typical sound range will be between 60-85 db.
Due to the wide variety of blades available, CTD cannot warrant that maximum allowable OSHA sound limits
can be met--particularly during the cutting cycle.
Cutting Plastic:
Plastic can be cut as easily as wood on the 200R Series Saws. However, because of its elastic properties, the material
can deflect as the blade passes through. Therefore, it is important to clamp the material as close as possible to the
blade and support it by use of fixtures. CTD offers Horizontal and Vertical clamps for this application (see Page No. 9)
Additional tooling may be required. Special carbide blades are avaialble for cutting plastics.