G.shdsl Router User Manual
The different Protocols need to setup difference WAN parameters. After knowing the Protocol
provided by ISP, you need the following necessary WAN parameters to set it up.
Bridge EoA
Route EoA
IPoA
PPPoA
PPPoE
VPI:
VCI:
Encapsulation:
Gateway:
Host Name: (if applicable)
VPI:
VCI:
Encapsulation:
IP Address:
Subnet Mask:
Gateway:
DNS Server:
Host Name: (if applicable)
VPI:
VCI:
Encapsulation:
IP Address:
Subnet Mask:
Gateway:
DNS Server:
Host Name: (if applicable)
VPI:
VCI:
Encapsulation:
User Name:
Password:
DNS Server:
Host Name: (if applicable)
IP Address: (if applicable)
VPI:
VCI:
Encapsulation:
User Name:
Password:
DNS Server:
Host Name: (if applicable)
IP Address: (if applicable)
Step 5: Install the SHDSL Router
!
To avoid possible damage to this Router, do not turn on the router before Hardware
Installation.
9
Connect the power adapter to the port labeled DC-IN on the rear panel of the product.
9
Connect the Ethernet cable.
Note: If the 1-port router is directly connected to PC or NB, the Ethernet cable has to be a cross
over one. If the 1-port router is connected to hub or switch, be sure that the hub or switch
supporting auto-sensing. If yes, both cross over and non-cross over Ethernet cable are
suitable. If not, only straight through Ethernet cable could be used. The 4-port router
supports auto-MDIX switching hub so both straight and cross-over Ethernet cable can be
used.
9
Connect the phone cable to the product and the other side of phone cable to wall jack.
9
Connect the power adapter to power source.
9
Turn on the PC or NB which is used for configuration the Router.
18