I-DSL64 USER’S MANUAL
8
To install the
I-DSL64
, proceed as follows:
Step 1
Connecting the
I-DSL64
to the DSL (U interface)
Connect the DSL port labeled
Line
on the rear panel to the remote site.
Step 2
Connecting the G64KC (to other co-directional equipment)
Connect the DTE port labeled
Data
on the rear panel to the co-directional
equipment using twisted pair cable.
Step 3
Connecting the Power Adaptor to your
I-DSL64
Connect the power to the port labeled
AC 90~264VAC
on the rear panel of your
I-DSL64
.
Step 4
Turning on the power
Turn on the power switch labeled
POWER
on the rear panel of your
I-DSL64
.
The PWR LED lights up to indicate the power is normal. All the LED’s on the
front panel (except for the PWR LED) will blink for five seconds. The LCD will
show the following:
** I-DSL64 **
==========
After blinking for five seconds, the LED’s will turn off, and the I-DSL64 will
begin a self-test. The local system tries to synchronize with the remote site.
After the initial setup, you can modify the configuration by using the LCD and the four
push buttons (Left arrow, Right arrow, Esc, Enter) on the front panel.
