Instructions for Use
Assist
X Mobil
|
25
EN
1
LED Battery
empty
charging
full
LED
flashes
green
, when 100% charged and connected to the power supply.
3
AssistX
Port
for many common sensors/switches
(jack plug 3.5 mm pink)
Connect sensor/switch
Quickly insert the sensor/switch into the AssistX Port. If the plug is inserted
too slowly, the sensor/switch may not be identified or may be identified
incorrectly. The LED on the transmitter flashes red, do not press the switch or
sensor for about 2 sec until you hear a beep and the LED stops flashing.
Unplug sensor/switch
For safety reasons a
6
call is triggered whenever the sensor is plugged off.
To avoid triggering a call, switch off the transmitter before disconnecting the
sensor.
9
Output socket
(Alarm signal adjustable via
Relay Mode
)
With the
Mono Jack Plug
you can tap 1 & 2, with a
Stereo Jack Plug
1,2 & 3:
1
Common contact
2
Normally open contact (NO)
3
Normally closed contact (NC)
If the sensor/switch is unplugged (safety-critical!) during a call has not
yet been completed (if it is not confirmed at the transmitter of the cal-
ler), the LEDs on the transmitter light up orange and a warning sounds.
If the call is completed by pressing the button on the transmitter, the
warning disappears.
6
Alarm Display
Disconnection alarm at the transmitter
Battery
alarm
at the transmitter
S
B
1
3
2
