2-3
ProRACK 8020
Mounting the ProRACK In Your Rack
Follow these steps to install the slide rails on the ProRACK
chassis and mount the ProRACK in your equipment rack:
1) Slide the smallest interior portion of the slide completely
out of the assembly.
2) Mount the smallest interior portion of the slide to the
chassis, using the #6/32 screws provided.
3) Mount the forward bracket (smallest of the pair) to the
front of the largest portion of the slide. Use two of the
#10 flat head screws provided.
• The flat head of the screw will be on the inside of the
slide.
• Put a flat head screw washer next to the bracket
assembly, followed by a lock washer and a nut.
• Adjust the bracket until it is even with, or slightly
ahead of the front of the large portion of the slide.
• Tighten the screws and nuts.
4) Mount the rear bracket (longest of pair) to the rear of the
largest portion of the slide.
•
This bracket is an extender. You will need to match up
holes that will let you mount the bracket to the rear rail.
•
Hand tighten the screws and nuts. Tighten these after
the ProRACK is installed.
5) Reassemble the slides.
6) When you mount the ProRACK, the front of the bracket
will mount to the rear of your rack’s forward rail. The
rear extender may be mounted in front of, or behind the
rear rail. The brackets are mounted to the RETMA rails
using #10 screws.
