28
MB-P201
3) Use the <PgUp> and <PgDn> keys to toggle between the
floppy drive types. The supported drive types are:
5.25" - 360 KB
3.5”
- 720 KB
- 1.2 MB
- 1.44 MB
- 2.88 MB
After you find your floppy drive type, press the <Enter>
key. Repeat this procedure for Floppy drive B:, or press
<Enter> again to skip to the next step.
4) Use the <PgUp> and <PgDn> keys to toggle between the
different hard drive types.
The lower right hand side of the Setup menu displays
information about your system board:
Base Memory Size
The amount of base (conventional)
memory, 0 to 640 KB.
Extended Memory
The amount of expansion memory
Size
extended beyond base memory.
Other Memory
Any other type of memory, usually
the memory above base and below
1 MB.
When you have made all the necessary changes, verify that
the settings are correct. Press the <Esc> key. The screen
displays the following:
Write data into CMOS and exit (Y/N)? Y
Type “Y” or “N”, and press <Enter>. Entering “N” will
send you back to the Setup menu, where you can make
additional changes. Entering “Y” causes the system to accept
the changes. The screen clears and the system reboots.
