CSI Alfa Laval SolidC-1, Инструкция по эксплуатации

Страница: 9 / 38

CONTACT CSI FOR MORE INFORMATION | CSIDESIGNS.COM | SALES@CSIDESIGNS.COM | 417.831.1411
3 Installation
Study the instructions carefully and pay special attention to the warnings! Always check the pump before operation.
- See pre-use check in section 3.3 Pre-use check, page 10
The large pump sizes are very heavy. Alfa Laval therefore recommends the use of a lifting crane when handling the pump.
3.2 Installation
S Stteepp 11
!
A Allw waayyss read the technical data thoroughly.
(See chaper 6 Technical data)
!
A Allw waayyss use a lifting crane when handling the pump.
A Allw waayyss have the pump electrically connected by authorised
personnel. (see the motor instructions).
N NO OTTE E
In case of shaft seal leakage, the media will drip from the slot in
the bottom of the adaptor. In case of shaft seal leakage, Alfa
Laval recommends placing a drip tray underneath the slot for
collecting the leakage.
C CA AU UTTIIO ON N
Alfa Laval cannot be held responsible for incorrect
installation.
W WA AR RN NIIN NG G::
Alfa Laval recommend the installation of a lockable
repair breaker. If the repair breaker is to be used as
an emergency stop, the colors of the repair breaker
must be red and yellow.
C CA AU UTTIIO ON N
The pump does not prevent back flow when
intentionally or unintentionally stopped. If back flow
can cause any hazardous situations, precautions
must be taken e.g. check valve to be installed in the
system preventing above described.
S Stteepp 22
Ensure that there is sufficient clearance around the pump (min.
0.5 m)(1.64 ft).
NOTE!
US pumps have no shroud
TD 241-005/1
S Stteepp 33
Check that the flow direction is correct.
Outlet C Coorrrreecctt!!
Inlet
TD 241-006
9