For correct control of the revs you have to specify what range of the revs
our spindle has (taking into account the inverter settings and eventually
the ratio). Select the „Config/Spindle Pulleys..” menu position. If we use
one ratio then enter „Min” and „Max” revs. Approve it with „OK.”
Last thing related with revs controlling is the choice of analog output, which
will be used. Select from the menu the „Config/Config PlugIns”, and next in
the window click the „CONFIG” next to the „CSMIO/IP”. Go to the „Spindle”
tab, in the „Spindle DAC” group, select „Enable” and on the „Select Analog
Output” list select the analog output.
Again, during the startup the diagnostic window may be helpful. In
the „Analog IO” tab, you can view the current voltages on the
analog inputs and outputs. When we configure the spindle, then in
the MDI tab you can enter e.g. M3 (enter), S2000 (enter). It should
cause the spindle to switch on (right revs) and the revs setting to
2000 rpm. In the diagnostic window, you can see switched digital
outputs and the voltage on analog output.
Check carefully the inverter settings before switching the spindle, incorrect configuration may cause
permanent damage of the spindle, which the warranty does not cover.
Pay attention if the left/right revs are switched correctly – starting the work with incorrect revs directory
may cause tool damage.
C S - L a b s . c . – C N C C S M I O / I P - M c o n t r o l l e r
Page 43
