Crytec D50MB, Руководство оператора

Страница: 11 / 30

MINI TRACKED DUMPER
9
GB
Following the assembly directions below, you
will assemble the machine in a few minutes.
Handlebar Assembly
ASSEMBLY
Align the holes of the handlebar with the mount
bracket and secure each with a spring washer,
flat washer and a M10x20 bolt . Fasten each
handlebar support onto the engine deck with a
spring washer, flat washer and a M8x25 hex bolt.
Panel (Bottom)
Position the bottom panel inside the mounting
bracket. Align the holes with the mounting
bracket. Insert a long pin through holes and
secure each side with a flat washer and cotter pin.
Tipping Handle & Engine Guard
Place the engine guard inside the mounting
bracket and align with the mounting bracket
holes. Secure panel left side with two M8x30
hex bolts, four washers and two nuts. Mount
the tipping handle on panel right side. Align
holes and fasten with two M8x35 hex bolts,
four washers and two nuts.
Panel (Rear) & Extendable Left/Right Side
Insert the extendable sides into mounting slots
located on the bottom panel and fasten each
at the bottom with two L pins and locknuts.
3
M8 X 30
1
1
2
3
M8 X 25
1
2