Crystal CRIF600, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 6 / 7

6
12. SERVICE
A)
If the appliance does not work satisfactory or at all, check as follows:
ƒ The temperature inside the appliance is not cool enough, check whether:
¾ The appliance is in the vicinity of a heat source and thus should be moved.
¾
The condenser is covered with dust and dirt and should be cleaned.
¾
The settings of the electrical thermostat-thermometer have been changed.
¾
The door of the appliance is not properly closed.
¾
The products are placed recently and the appliance needs more time to achieve the desirable temperature inside
the cabinet.
ƒ Although connected, the appliance does not work, check whether:
¾
There is power in the socket and the plug is properly inserted in the socket.
¾ There is power supply network failure.
¾ The power control fuse to your appliance has been destroyed.
¾ Your appliance’s power cable is damaged.
ƒ Your appliance emits a metal noise, check whether:
¾ There is contact between your appliance and other metallic objects.
¾ The appliance is properly leveled on the floor.
B)
If the door does not close satisfactory (does not revert or does not secure properly) you may proceed as follows:
C)
In case that a service must take place in the compartment of the engine,
note that it is necessary to be done by a
qualified technician
and proceed as follows:
ƒ Remove the metal grill panel from the appliance following the instructions in paragraph 11.
ƒ Unscrew the two screws that hold the sliding engine base, which are located at the front, just behind the grill panel.
ƒ Pull towards you the engine base
without moving the appliance.
ƒ Proceed to the service of the engine.
ƒ After you have finished, repeat the steps in the inverse order so that your appliance gets back in operation.
D)
If the power cable is damaged, the manufacturer must replace it or a qualified person from the service department,
or by similarly specialized personnel, in order to avoid danger.
E)
Do not cause any damage to the cooling circuit by the intervention of unauthorized personnel. Advise the
manufacturer and assign such works only to specialized technicians.
Keep this booklet as well as all documents provided with your appliance.
ƒ Place a sharp object - such as a small screw driver, stabber, nail
etc - in one of the holes which are located at the top of the torsion
bar, which is located on the upper side of the door under the top
hinge.
ƒ
By applying resistance with the stabber
, unscrew with the
screwdriver the kingpin which is screwed on the top of the torsion
bar (Fig. 7).
ATTENTION, HOLD THE SHARP OBJECT
STEADY TO AVOID AN INJURY BECAUSE THE SPRING
IS UNDER TENSION.
ƒ By using a sharp object, turn the top of the torsion bar
anticlockwise until you are able to screw promptly the kingpin in
the next hole. After you screw the kingpin remove the sharp
object.
ƒ Examine if the door secures satisfactorily following the above-
mentioned procedure. If not, repeat the above steps.
TOP OF
TORSION BAR
DOOR
SHARP
TOOL
CANOPY
KINGPIN
SCREW
DRIVER
HINGE
Figure 7