Crystal CRIF600, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 2 / 7

2
1. INTRODUCTION
Proper installation and maintenance are essential for best use of your appliance. It is therefore necessary to
carefully read the instructions of this manual.
2. TRANSPORT (Figure 1)
3. INSTALLATION OF THE APPLIANCE
•
Unpack the appliance. In order to remove it from the pallet use a screwdriver and unscrew the 4 screws (Fig. 2).
•
Make sure that the appliance is stable and in horizontal position.
•
Perfectly level the appliance by adjusting the adjustable stands that are provided with the appliance.
•
Never install the freezer in a room exposed to direct sun radiation nor in the vicinity of a heat source such as
cooker, stove, heater, fireplace etc.
•
Avoid installing the appliance in confined rooms, in rooms with dampness without airing or in wall recesses.
•
The clearance behind the appliance must be at least 10 cm distance from the wall or other voluminous objects. This
clearance is the minimum required to ensure normal ventilation of the refrigeration mechanism. You will find one
spacer with two fixing screws within the appliance, which obtains the airing space of 10 cm after fitting it at the
back of the freezer (Fig. 3A).
•
Inside your appliance, you will find:
1.
Inox door handle and two inox screws inside a plastic bag.
2. Offset handle and two stabilization screws inside a transparent bag.
3. Shelves for products placement.
4. Four hooks per each shelf for its proper stabilization. (see figure 3).
5. One pair of keys for the lock (see figure 1a).
4. ELECTRICAL CONNECTION
Figure 1a
Make sure that the feed cable and the socket are appropriate for the appliance’s power. In case of doubt, contact a
qualified technician.
Before inserting the plug in the mains outlet, make sure the voltage mentioned on the nameplate inside the appliance
(on the top right) compiles with the one of your network. A discrepancy of +/- 10% is acceptable.
Too high or too low voltage network may seriously damage the compressor. Such damages are not covered by the
guarantee. The appliance must be earthed as prescribed by the relevant legislation whereas it is indispensable for your
personal safety. The manufacturer has provided for earthing in the electrical installation and external surface of the
appliance.
NOTE: Upon start up, running may be noisy. Noise will only last for the engine “running in” time and will
decrease progressively.
5. SHELVES (Figure 3).
Place the shelves upon the hooks carefully so that the two
fitted wires of each shelf to be placed at the cabinet’s back (Fig 3).
That way, the proper airflow at the cabinet’s back is ensured.
Figure 1
Always transport the appliance in vertical position, do not
overturn it and do not load it in leaning position.
SCREW
SCREW
SCREW
Figure 2
Β
Α
Figure 3