Crystal CRIF600, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 3 / 7

3
6. OPERATION
Once the appliance is installed, wait for at least 30 minutes before start – up. Afterwards, plug in the appliance.
The thermostat and the operation switch “O/I” are located behind the fitted metallic grill panel. In order to operate the
appliance, the operation switch must be on.
Start up the appliance with no load and make sure the door is properly closed.
Wait for at least two hours in order to achieve the required temperature inside the freezer. Then, place the products.
The compressor will not restart immediately, in case of starting up the appliance straight after terminating its operation –
either via the thermostat or due to power failure –. This is normal. The compressor will automatically start soon after.
For your appliance’s protection, always wait for fifteen minutes before each restart.
Do not use any electrical devices inside the storage places for appliance’s foods.
Keep the air openings in the cover without any obstacle.
This appliance is not to be used by individuals (and kids also) with low physical or mental abilities or lack of
experience and knowledge but only if they are supervised or specific orders were given by someone who is responsible
for their safety.
The kids should be supervised in order to avoid playing with the appliance.
7. PRODUCTS LOADING (Figure 4)
8. ELECTRICAL THERMOSTAT - THERMOMETER (Figure 5)
Place the products on the shelves without blocking the proper
airflow inside the cabinet (Fig. 4). Do not place products at the top
shelf, which would block the airflow exit due to their height, from the
fan to the cabinet top. The distance of 10 cm among the products and
the fan is necessary.
The thermostat is located behind the fitted metallic canopy at
the top of the freezer. Our company sets it so that your appliance
could be able to maintain your products to an average temperature
from -24 to -18
ο
C according to its climate class (40
ο
C temperature
and 40% relative humidity of the environment).
If you wish, you can change the temperature average inside
the cabinet by programming the electrical thermostat-thermometer
properly.
The necessary commands are given below.
1
Í
1
Í
Figure 4
Figure 5