Crystal Vision
Appendix A
Bypass
Selecting Bypass Control will set the Q-Down-ATG 3G to bypass mode whenever the
input and the selected output formats are the same. In bypass mode the analogue
output selection remains active along with the analogue RGB and YUV proc amps
and the delay controls. The digital proc amps will be disabled and the SDI delay
through the Q-Down-ATG 3G will be set to its minimum processing delay. (SD
approximately 2
S delay and HD less than 1
S delay). The Bypassed LED will
illuminate when bypass mode is active.
Note
:
Q-Down-ATG 3G does not support a 3G output so bypass with a 3G
input is not possible.
Output for incompatible input
Should the video input format and output format selection become incompatible,
which would be the case if the input is a lower bit rate than the output selection,
the output can be set to go to black, blue or muted to no output.
Presets
Up to 16 user configurations may be stored and recalled via Statesman or recalled
using the Q-Down-ATG 3Gs GPI inputs. The Preset tab also gives access to the
factory reset controls.
Presets and factory reset
Saving and recalling presets
The current board settings can be saved in one of 16 locations to be recalled as
desired. This allows the user to store and recall up to 16 different configurations for
later use.
To save the current settings, tick the selected preset location and click on Store. This
will write the current settings into this location.
Note
:
If the selected location contains previously saved setting information it
will be over- written by the new setting data.
To recall previously stored setting information, again tick the selected location and
click Recall.
Q-Down-AG 3G/ATG 3G User Manual R2.1
61
11 July 2019
