Crystal Vision
Appendix A
Note:
The position of the on-board links PL2, PL3 and PL4 must also be
set to give either an SDI output or analogue output as required. See
Module Configuration for link setting details.
Video output format selection
Analogue video output format
As the Q-Down-ATG 3G supports both Standard Definition and High Definition
analogue output formats, the final analogue output presented will be determined by
both the Output Format and Analogue Output selections made. Setting the output
format to SD (selected by checking the appropriate radio button as seen above) will
allow the analogue output format to be selected from any of the available choices. If
one of the High Definition output formats were to be selected, the analogue outputs
would be limited to either YUV or RGB.
See the installation chapter for rear module connection details.
Optical I/O
The Q-Down-ATG 3G has the option of either receiving an optical input or
transmitting an optical output once the necessary optical equipment has been fitted. If
the optical receiver module is fitted the fibre optic I/O input enable will allow the video
input to be selected between the input BNC and the optical input.
Note:
The input loop-though will show whichever of the inputs are selected.
With the fibre transmitter fitted the optical output can also be enabled or disabled by
checking or un-checking the output enable check box.
Note: The output BNCs remain active when the optical output is either
enabled or disabled.
Q-Down-AG 3G/ATG 3G User Manual R2.1
52
11 July 2019
