SWITCH PANELl OR BUTTON PANEL (if fitted)
!
!
!
!
!
!
!
Starting the fire
Press and hold the
power button
!
continuously until the red light illuminates next to the
!
symbol
(this takes typically 1 second). As the red light illuminates release
immediately the power button. The red light will then flash as the
burner is being lit. While the burner is lighting the red light will flash.
When the burner has lit the red light will stop completely. The burner
will be at maximum burner rate when first lit.
!
Note: If the power button is pressed for too long or too short a time
this is taken as an accidental press and the fire will not ignite for
extra safety reasons. It is to try an ensure that the starting operation
of the fire will be most unlikely to be done other than intentionally by
an adult. If not done correctly , wait a few seconds and try again.
If you wish to power down the fire so it will not start even if any of
the power symbol buttons are pressed, slide the “power Isolating
switch to the “0” position ( perhaps a good idea to do in the event of
leaving the fire not operated for long periods like the summer months
or when going on long holidays).
!
!
!
!
12
!
Red indication light
!
!
!
!
Press to increase 9lame
!
!
!
!
Press to decrease 9lame
!
!
!
!
Press power button and hold for a second to start 9ire
(release when red indication light appears).
!
Press also to stop 9ire
!
