HANDSET IS PAIRED ORIGINALLY IN THE
FACTORY FOLLOW INSTRUCTIONS BELOW
ONLY IF HANDSET UNPAIRED OR REPLACED
!
Pairing the Handset to the Fire Control
!
With 2 good quality AA alkaline batteries in the handset in the direction
shown inside, if the handset can be paired with a control, it will have the
display with the word TESC on the display as shown adjacent.
!
The handset must be within 1 metre ( 3 feet) of the fire when pairing
!
!
After fitting the batteries as above (and with the
power
isolator slide switch
on the TESC Fire control on the fire put in the on position I), simultaneously
press and hold the – and + buttons on the fire control (i.e. not the handset)
until the handset makes a noise and the display shows the pattern as shown
here.
Hold the handset in one hand so your fingers wrap around the back of the
operating buttons area of the handset. A green unlock light will illuminate
when the handset has detected your hand. The green light must be
illuminated in this way for any of the command buttons to accept commands
to operate the fire control.
While the display is as shown, and holding the handset as described, press
the “SET” button with the other hand to finish off the pairing of the
handset to the Fire Control and to enter the setup the time of day on the
handset. As shown earlier in the instruction
!
N.B. If the display returns to the one shown above with the word “TESC”
shown, then too much time has passed before pressing “SET” and so the
handset has not paired yet. Simply repeat pairing again.
N.B. Only ever press “+” and “-“ buttons together when pairing handsets. If
done afterwards this will break the pairing made and a factory reset of the
handset will need to be performed See
Factory Reset of display handset
!
!
!
!
!
!
!
!
!
8
