Crystal Enterprises Barrica Series, Руководство по сборке

Страница: 8 / 20

8
8. ASSEMBLY OF THE STEEL WALL (CH)
VERY IMPORTANT:
Don’t fold or wrinkle the steel wall during the installation. Unfold it very carefully. Put a
cardboard under the metal wall in order to unfold it easily and avoid it to be scratched with the floor contact
(possible cause of rust).
Installation must be done by at least 2 people
, on a sunny day and with no wind. During the installation, don’t fold
the metal wall and handle it very carefully.
Don’t unfold neither break the lower or upper guides during the pool assembly.
Very important: Please wear gloves during the pools assembly, to avoid cuts with the metal hedges.
a) Unpack the coiled pool wall (CH) and place it vertically (the
inner wall sticker up) on a cardboard at the centre of the pool circle.
This will help you to unroll it easily and make sure that it doesn’t get
scratched by rubbing against the ground (fig. 8).
IMPORTANT: THE SKIMMER HOLE IN THE ROLLED STEEL WALL MUST BE
AT THE TOP OF THE POOL.
b) Start unrolling the wall, placing the bottom corner of the wall in
the low metal guide (M) (fig. 9).
b) Unfold the metal wall, following the circle till the wall will be
assembled inside the low metal guides (M). (fig. 10)
c) Join the two ends of the metal wall so that the screws (TO)
can pass inside both holes, leaving the nuts (TU) and the washers
(AR) at the outer side (fig. 11).
Cover the ends of the junction and the wall boards (inside of
the pool) as well as the screws, with the PVC tape in order to
protect the liner from the contact with this objects, that may
cause breaks in it. The PVC tape must be firmly stuck in this
area and if it was necessary, use adhesive tape or similar to
fix it to the wall.
Very important : Put all the screws in the metal wall, from the bottom
up, excepting the last hole. Tighten strongly , all the screws with
screwdriver. If the assembly and the fixation of screws and nuts is not
correct, the guarantee of the pool could be void.
Install the plastic profile (PL) around all the perimeter of the pool.
Cut the excess of the last section of the profile (PL) to fit perfectly.
Be very careful not to damage the liner.
Before installing the wood slats, cut the skimmer
hole with a pair of scissors for metal.
Smooth the edges to avoid the liner to be
damaged or cut.
(fig. 12)
fig. 8
fig. 9
fig. 10
fig. 11