10
These faucets are designed with a flow control adjustment knob (decrease or
increase the flow of the water) on the right side of the faucet body. It will be
desirable to lock in a lower flow of the sparkling water rather than allowing it to be
adjustable. This can prevent splashing in self service applications and will maximize
carbonation profile of the water (the slower the pour the better the bubble profile).
The faucets can also
“
wander
”
or increase to full flow on its own with use. To lock in
a set flow rate, these faucets are supplied with a Stainless Steel lock washer on the
adjustment knob, once tightened down it will prevent the knob from being turned or
moving on is own.
Sparkling Water Flow Adjustment Lock Out.
Upon start up of the system, the CR
-
SSQ1231 Faucets used on the CBR
-
V1, CBR
-
V2, CBR
-
V3,
LIT
-
V2C and LIT
-
V3C dispensing towers will need the flow rate adjusted and set.
To set the flow rate & lock the flow adjustment knob (make sure system is on and cold, and CO2 open):
•
Locate the black plastic three pronged adjustment knob on the right side of the faucet, and check that
you can freely turn it (you may need to loosen the Phillips head set screw a little so the knob can turn).
•
With a cup under the faucet pull open the handle so sparkling water is flowing. While water is flowing
turn the knob to adjust the flow rate (clockwise or away from you to decrees the flow).
•
Once a favorable flow rate is determined, tighten the set screw (while not turning the knob) so teeth of
washer bite in to the plastic, this will lock the knob so it can no longer be turned or move out of
adjustment on its own.
•
Check the flow rate again by filling a cup and confirm if the knob is properly tightened down so it cant be
turned by hand.