CruzPro MaxRp110, Руководство пользователя

Страница: 13 / 48

Page 13
Turning Alarms ON/OFF
To “arm” the alarms, press and hold the
$
key 1/2 second. The Bell symbol
will be displayed when the alarms are “armed”. To disable the alarms press and
hold the
%
key for 1/2 second. Any press between 1/2 and 2 seconds will
work. A press of less than 1/2 second or longer than 2 seconds will be ignored.
When an alarm value is breached, the affected display or barchart will flash and
if the alarms are armed, the internal 85dB alarm buzzer will sound. If the alarms
are not armed, then the display will flash but no audible alarm will sound.
Setting High and Low Alarm Values
To View and/or Set the High Alarm value for any of the five current displays,
press and hold the
$
key for ten seconds (until you hear a long beep). To
View and/or Set the Low Alarm value for any of the displays, press and hold the
%
key for ten seconds. The alarm value, display identifier (1, 2, 3, L or r) and
the word “HiAL” or “LoAL” will be displayed as shown in Figure 11. Quick
press the
&
key to select the desired display (1, 2, 3, L or r). Press and hold
the
%
or
$
keys to change the alarm value. Press the
&
key for 1 second
(until the long beep) to accept the new alarm values, save them to memory and
exit the Alarm Editor mode.
To prevent confusion, the High and Low alarm values are unique for each Data
Source (NMEA1A, NMEA2B, etc.). For example, if you change the high alarm
Figure 11 - Alarm Editor
Editing the Hi Alarm
for display #3