USING THE WHITE WIRE TO ACTIVATE THE REAR-VIEW CAMERA AND/OR PARK ASSIST
Aside from coding the vehicle using the Steering Wheel Controls, you can code the vehicle using the loose WHITE
wire on the CAN module and dip switches 3 and 4.
Dip 3 = Rear-View Camera Enable
Dip 4 = Park Assist Enable
Step 1
- With the T-Harness and interface module properly connected, turn the ignition to the “ON” position.
Wait for the head unit to power on then proceed to the following steps.
On the CAN module:
1. Set dip switches 3 and 4 on the CAN module ON or OFF
(Depending on Coding or Decoding)
2. Place 12V on the WHITE wire for approx. 5 Seconds.
During the coding process, the Red
and Blue LED will begin to sh.
3. After the head unit has began to reset,
release both buttons.
The Red and Blue LED’s will glow solid
to identify the coding has been
completed.
THE PARK ASSIST ND REAR-VIEW CAMERA
OPTION WILL BE AVAILABLE ON THE MENU.
After coding is complete, you must wait 60 seconds until trying to code or decode the vehicle again.
Rear-View Integration Interface for
PORSCHE Vehicles with PCM-3 or PCM-3.1 Systems
PCM-3
R
INTERFACING SOLUTIONS
Sightline
REAR-VIEW INTEGRATION
Crux Interfacing Solutions • 6860 Canby
Ave., Suite 1
16, Reseda, C
A 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www
.cruxinterfacing.com
9 of 10
rev.051718
